Everything you need to make a wooden terrace, shutters, or any other furnishing project using our edged douglas timber, our floor battens and other landscaping sleepers.
C1 : Two radii on top and below, for half the thickness of the panel
C2-1 : A 5mm radius on top
C2-2 : A 5mm radius on top and 5mm radius below
C3 : A 5mm radius on top, 1cm flat and a 45° bevel below
Warning, this machining option involves a reduction of the surface on the lower part, about :
30 mm for a thickness of 40 mm
28 mm for a thickness of 38 mm
16 mm for a thickness of 26 mm
10 mm for a thickness of 20 mm
8 mm for a thickness of 18 mm
C4-1 : A 4x4mm bevel on top
C4-2 : Two 4x4mm bevels on top and below
C5 : A 45° bevel on top, 1cm flat and a 5mm radius below
Warning, this machining option involves a reduction of the surface on the higher part, about :
30 mm for a thickness of 40 mm
28 mm for a thickness of 38 mm
16 mm for a thickness of 26 mm
10 mm for a thickness of 20 mm
8 mm for a thickness of 18 mm
Details of available finishes
If you select “None: the product will be delivered without finish. It will be up to you to apply the finish of your choice before use.
BLANCHON Solid’OIL oil-wax: with a single coat, it impregnates, dyes and protects the wood in a single operation. With high resistance, on contact with the wood, it creates an interactive mesh that deeply nourishes and preserves the wood. The application of oil can bring up the bibers of the wood during its drying after leaving our workshop. A simple fine-grained sanding (approx. P150) once our panel is recieved will remove a possible slighltly "rough" appearance. It will be necessary to iron a layer og oil every 6 to 12 months depending on use.
Matt finish.
> Natural Shade: “warms up” the wood, i.e. darkens it slightly.
> Snow Shade: gives a slightly whitened effect, granting a soft and contemporary appearance.